User Manual Q&AAnswer
Jan 21, 2025 - 10:16 PM
To adjust the flow rate using the COMAP Autobalancing Thermostatic Radiator Valve Autosar, follow these steps:
1. Use the embedded tool that displays 12 adjustment positions. This tool is located on the valve itself.
2. Using a screwdriver, turn the tool as shown in the diagram provided in the manual.
3. Place the number corresponding to the desired flow rate opposite the indentation on the tool.
Note: The flow rate adjustment is done by turning the tool, not the valve itself.
For the nominal level setting, follow these steps:
1. Close the valve completely and mark it with one position.
2. Open the valve and count 6 marks. This means the valve is now open at the nominal opening.
3. To install the thermostatic head, remove the plastic cap.
4. Put the thermostatic head in position 5 on the valve.
5. Firmly push the head onto the faucet and xxxx it in hand tight.
Please refer to the instruction manual for more detailed information and illustrations on adjusting the flow rate and installing the thermostatic head.
Add New Comment