User Manual Q&AAnswer
Jan 21, 2025 - 08:10 PM
To assemble the Campingaz 400 SG Xcelerate Double Burner and Grill, follow these steps:
1. Assembling the stand (for model 600 SG):
a. Turn the appliance upside down on a clean, flat surface.
b. Pull out the side shelves located under the stove body by releasing the plastic clamps on the aluminum telescopic legs.
c. Unfasten the rolled-up textile shelf attached with hook-and-loop straps.
d. Unhook the telescopic feet from their housing under the stove by pushing in button B, sliding the tube to release it, and pulling it out.
e. Repeat the operation for the other 3 legs. xxxx each foot into the 4 corners of the plate, ensuring they are tight.
2. Fixing the side shelves:
a. Pull out the support wire under the shelf by compressing wire F.
b. Lodge the ends of the support wire in the holes located on the sides of the legs. Use the lower holes on the front pair of legs and the upper holes on the rear pair of legs.
c. Place a shelf on the side support of the appliance and fix the 2 retaining screws. Hook the support wire into the notches provided under the shelf.
d. Repeat this operation for the second shelf.
3. Fitting the central textile shelf:
a. Unfold the shelf by opening the jointed uprights progressively on each side.
b. Place the ends of the uprights in the plastic rings rotating freely on each foot. Check that the shelf is well tensioned.
4. Adjusting the stability:
You can adjust the stability of the appliance on the ground by using the adjustment screws at the end of each foot.
Please refer to the instruction manual for detailed illustrations and further instructions on assembling the Campingaz 400 SG Xcelerate Double Burner and Grill.
Add New Comment