How do I install the Meitrack T333L GPS Tracker in my vehicle? (meitrack T333L GPS Tracker User Guide)

Answer

manuals.plus

Jan 21, 2025 - 05:18 AM

To install the Meitrack T333L GPS Tracker in your vehicle, please follow these steps:

1. Installing the SIM Card:
- Power off the device before installing the SIM card.
- Loosen the screws and remove the front cover of the device.
- Insert the SIM card into the card slot with its gold-plated contacts facing towards the Printed Circuit Board (PCB).
- Close the cover and tighten the screws.

2. Charging the Device:
- Connect the T333L GND (-Black) and Power (+Red) wires to a 12V or 24V external power supply for charging.
- Ensure that the T333L is charged for at least three hours. It is recommended to charge it for eight hours.

3. Installing GPS and 4G Antennas:
- Connect the 4G antenna to the connector labeled "GSM" and hide it in any place of the vehicle.
- Connect the GPS antenna to the connector labeled "GPS" and ensure it is facing up to the sky.

4. Installing the I/O Cable:
- The I/O cable is a 12-pin cable that includes power, analog input, digital temperature sensor input, and negative/positive input and output interfaces.
- Connect the power cable (red) and ground wire (black) to the positive and negative charges of the vehicle battery, respectively.
- Connect the other necessary cables according to your requirements, such as door trigger signal cable, ACC cable, fuel level sensor, etc.

5. Mounting the T333L:
- Tighten the four screws to securely mount the T333L in your vehicle.

Please note that these are general installation instructions. For more detailed information and specific installation requirements, refer to the Meitrack T333L GPS Tracker User Guide provided with the product.