How do I mount the Honeywell C7355A IAQ Monitor? (Honeywell C7355A IAQ Monitor Mounting Instruction Guide)

Answer

manuals.plus

Jan 21, 2025 - 04:57 AM

To mount the Honeywell C7355A IAQ Monitor, follow these steps:

1. Choose a suitable location: The monitor should be installed indoors in a clean, dry location away from windows, air ducts, and other sources of environmental factors that may affect readings. If you mount the unit on the interior of an outside wall, make sure to insulate it properly to prevent outside air from affecting the sensor reading.

2. Wall Mounting: Install the monitor about 1.5m-1.8m (5-6 feet) above the floor in an area with good air circulation and average temperature. Ensure there is enough space for maintenance.

3. Ceiling Mounting: Install the monitor on the ceiling, about 2.5m-3m (8-10 feet) above the floor in an area with good air circulation and average temperature.

4. Disconnect power supply: Before beginning the installation, disconnect the power supply to prevent electrical shock and equipment damage. Ensure all power supplies are disconnected.

5. Separate the backplane: Rotate the backplane clockwise according to the direction of the arrow to separate it from the detector.

6. Punch out an opening: Use a screwdriver to punch out the appropriate opening on the backplane.

7. Pull wires through the hole: Pull the wires through the opened hole to connect them to the terminal block.

8. Unplug the terminal block: Unplug the terminal block from the contact pin.

9. Connect the cable: Connect the cable to the terminal block and secure it with the mounting xxxx .

10. Plug the terminal block back: Plug the terminal block back onto the contact pins.

11. Align and rotate the detector: Aim the dot located in the middle of two arrows on the side of the detector with the vertical lines on the backboard. Then rotate the detector following the "FIX" direction shown in the manual. This completes the RS-485 wiring.

Please note that these instructions are a summary. For more detailed instructions and illustrations, refer to the Honeywell C7355A IAQ Monitor User Guide and the Honeywell C7355A IAQ Monitor Mounting Instructions provided with the product.