How do I install the ELCO Lighting Pex 4 Inch Round Trimless Smooth Reflector Trim? (ELCO Lighting Pex 4 Trimless Reflector Trim Owner's Manual)

Answer

manuals.plus

Jan 21, 2025 - 04:13 AM


To install the ELCO Lighting Pex 4 Inch Round Trimless Smooth Reflector Trim, follow these steps:

1. Ensure that the power to the lighting fixture is turned off before beginning the installation process.

2. Start by attaching the Koto™ LED Module to the twist-lock design of the trimless smooth reflector. The twist-lock design allows for easy mounting.

3. Once the LED module is securely attached to the reflector, position the trimless spackle frame (EL4SFR) over the LED module and align it properly.

4. Secure the trimless spackle frame in place by using the appropriate mounting hardware or clips provided with the product. Make sure it is firmly attached to the ceiling or surface.

5. Connect the electrical wiring according to the local electrical codes and regulations. If you are unsure about the wiring process, it is recommended to consult a qualified electrician.

6. After the wiring is complete, carefully insert the assembled trimless smooth reflector and spackle frame into the ceiling or surface opening. Ensure that it fits securely and is flush with the surrounding area.

7. Once the trimless smooth reflector and spackle frame are properly installed, you can turn on the power and test the lighting fixture.

Please note that this is a general installation guide, and it is always recommended to refer to the specific instructions provided in the owner's manual for your ELCO Lighting Pex 4 Inch Round Trimless Smooth Reflector Trim.