How do I install DIAM-CRK-01 Crank Arm Kit Honeywell Diamond Accessories Spring Return Direct Coupled Actuators? (Honeywell MS7103 Diamond Direct Coupled Actuators Instruction Manual)

Answer

manuals.plus

Jan 21, 2025 - 04:04 AM

To install the DIAM-CRK-01 Crank Arm Kit for the Honeywell MS7103 Diamond Accessories for Spring Return Direct Coupled Actuators, please follow the steps below:

1. Ensure that the power to the actuator is turned off before beginning the installation process.

2. Remove any existing foot mount actuators, such as M6415, M7215, M8415, Honeywell Modutrol IV, Johnson M100, or Invensys MA Series, from the mounting location.

3. Position the DIAM-CRK-01 Crank Arm Kit in the desired location for installation. Refer to the "Possible positions of installation" section in the instruction manual for guidance.

4. Mount the DIAM-CRK-01 Crank Arm Kit securely using appropriate screws or fasteners. Ensure that the actuator is properly aligned and level.

5. To achieve an ingress protection rating of IP54, mount the actuator as shown in the diagram provided in the instruction manual. The IP54 rating applies to all mounting positions except for the cable-up position.

6. Once the actuator is securely mounted, connect the necessary wiring according to the wiring diagram provided in the instruction manual.

7. After the wiring is complete, double-check all connections and ensure that they are secure.

8. Finally, turn on the power to the actuator and test its functionality to ensure proper installation.

Please note that the above instructions are a general guideline. For specific details and illustrations, refer to the Honeywell MS7103 Diamond Accessories for Spring Return Direct Coupled Actuators Instruction Manual provided with the product.