How do I install the AVIPAS AV-POE4 4-Port Unmanaged PoE- PoE+ Switch? (AVIPAS AV-POE4 4-Port PoE+ Switch User Guide)

Answer

manuals.plus

Jan 21, 2025 - 03:57 AM

To install the AVIPAS AV-POE4 4-Port Unmanaged PoE- PoE+ Switch, please follow the steps below:

1. Choose a suitable installation location or cabinet according to the safety recommendations provided in the user guide.

2. Ensure that the power is disconnected before installing or removing the PoE switch. Operating the switch with its power on is prohibited to prevent injury or damage to the device.

3. Wear protective gloves during the installation process.

4. For desktop installation, place the PoE device on an even desktop surface. Make sure to reserve at least 10cm of space on both sides of the device for proper ventilation.

5. Connect the devices according to the PoE Switch connection diagram provided in the user guide. Ensure that the protective ground wire of each device is securely grounded. All power cables must not have any open parts exposed in the air.

6. After installation, perform a checklist to ensure everything is properly secured and connected:

- Confirm that all mounting parts (hanging ears and screws) are securely in place.
- Check the polarity of all cable connections and ensure they are correct.
- Verify that the wiring between every two devices is correct and secured, with no short circuits.
- Power on the switch and observe if the self-check process is performed normally.
- Check if the indicator lights on the PoE device are in the correct working mode.

Please note that the above instructions are a summary of the installation process. For more detailed information and illustrations, refer to the AVIPAS AV-POE4 4-Port Unmanaged PoE- PoE+ Switch Compatible User Guide provided with the product.