User Manual Q&AAnswer
Jan 21, 2025 - 03:46 AM
To install the Dynojet GSX1250F PCFC Fuel Controller on your Suzuki Bandit, please follow the steps below:
1. Start by removing the left fairing, left side panel below the seat, and the fuel tank.
2. Secure the PC6 in the trunk area using the supplied Velcro. Clean both surfaces with the supplied alcohol swab before applying the Velcro adhesive.
3. Route the PC6 harness along the left side of the bike and under the small frame crossover. Use the stock zip tie to secure the PC6 harness.
4. Attach the ground wire of the PC6 with the small ring lug to the negative (-) terminal of the bike's battery.
5. Route the PC6 harness down the right side of the bike and under the frame crossover that supports the fuel tank.
6. Route the PC6 harness along the stock main harness up to the throttle body.
7. Unplug the stock wiring harness from each fuel injector.
8. Plug the PC6 in line with the stock wiring harness and fuel injectors. Connect the wires as follows:
- BLUE wire to cylinder #1
- GREEN wire to cylinder #2
- YELLOW wire to cylinder #3
- ORANGE wire to cylinder #4
9. Locate the Throttle Position Sensor on the left-hand side of the throttle bodies.
10. Connect the GREY wire from the PC6 to the PINK/BLACK wire of the stock wiring harness using the supplied Posi-tap.
11. Reinstall the seat, left fairing, and left side panel.
For additional optional inputs, you can connect the Speed input by tapping into the PINK wire of the black 3-pin connector under the left side panel. If you need a 12V source for Autotune, you can use the GREY wire of the 3-pin connector for the tail light.
Please note that it is important to read and follow all instructions in the installation guide provided with the Dynojet GSX1250F PCFC Fuel Controller. If you have any further questions or need assistance, you can refer to the installation guide or contact Dynojet directly at 800-992-4993 or visit their website at dynojet.com.
Add New Comment