User Manual Q&AAnswer
Jan 21, 2025 - 02:38 AM
To install the SUNCO LIGHTING Sputnik LED Ceiling Light, please follow these steps:
1. Before starting the installation, turn off the power at the fuse or circuit breaker.
2. Install a junction box (not included) if you don't already have one.
3. Remove the xxxx caps from the mounting bracket and set them aside.
4. Secure the mounting bracket onto the junction box using the two provided screws.
5. Insert two short tubes and two long tubes into the Lamp Bracket as shown in the diagram.
6. Use a wrench, hex nuts, and lock washers to secure the short tubes to the canopy first. Repeat the same process for the long tubes.
7. Connect the four white fixture wires to the white wire connector and the four black fixture wires to the black wire connector.
8. Connect the supply wires to the fixture wires using the included wire nuts. Match black to black, white to white, and ground to ground.
9. Use the xxxx caps to secure the canopy to the mounting bracket.
10. Install four E26-base light bulbs.
11. Turn on the circuit breaker and test the light.
Please note that proper grounding is required for safety. This fixture is not suitable for wet environments and should not be installed directly over a heat source or on the surface of combustible material. Always follow regional and local laws or regulations during installation. It is recommended to wear safety eyeglasses and gloves during the installation process.
For further information and precautions, please refer to the SUNCO LIGHTING Sputnik LED Ceiling Light Installation Guide provided.
Add New Comment