How do I install the KUFATEC Rear Park Pilot system in my vehicle? (KUFATEC Rear Park Pilot Instruction Manual)

Answer

manuals.plus

Jan 21, 2025 - 02:22 AM

To install the KUFATEC Rear Park Pilot system in your vehicle, follow these steps:

1. Start by locating the Park Pilot control unit, fuse box, and CAN gateway in your vehicle. These components are typically found in the engine compartment or under the dashboard.

2. Connect the Park Pilot control unit to the CAN gateway using the provided cables. Refer to the manual for the specific cable routing instructions.

3. Locate the Body Control Module (BCM) in your vehicle. This is usually found under the dashboard or in the trunk area. Connect the Park Pilot control unit to the BCM using the provided cables.

4. Find a suitable ground pin in your vehicle and connect the ground wire from the Park Pilot control unit to it. Make sure to establish a secure and reliable connection.

5. Install the warning buzzer in a convenient location, such as the dashboard or near the driver's seat. Connect the buzzer to the Park Pilot control unit using the provided cables.

6. Install the rear sensors on your vehicle's bumper according to the manufacturer's instructions. Ensure that they are evenly spaced and properly aligned for accurate detection.

7. Connect the rear sensors to the Park Pilot control unit using the provided cables. Follow the cable routing instructions in the manual to ensure a neat and organized installation.

8. Once all the components are connected, test the system to ensure proper functionality. Follow the instructions in the manual to calibrate and adjust the Park Pilot system as needed.

For more detailed instructions and illustrations, please refer to the relevant sections of the KUFATEC Rear Park Pilot Instruction Manual. If you have any further questions or need assistance, you can contact Kufatec GmbH & Co. KG directly via email at info@kufatec.de.