User Manual Q&AAnswer
Jan 21, 2025 - 01:01 AM
Installing the anti-tip bracket is an important safety measure to prevent the range from tipping over and causing harm. Here are the step-by-step instructions for installing the anti-tip bracket for the Whirlpool WEC310S0LS electric range:
1. Remove the anti-tip bracket from inside the oven. It is usually located in the oven cavity.
2. Determine whether you will be using the floor or wall mounting method. If you have a stone or masonry floor, you can use the wall mounting method. If you are installing the range in a mobile home, you must secure the range to the floor.
3. Determine and mark the centerline of the cutout space. The mounting bracket can be installed on either the left or right side of the cutout. Position the bracket against the wall in the cutout so that the V-notch of the bracket is 12 1/2" from the centerline.
4. Drill two 1/8" holes that correspond to the bracket holes of the determined mounting method. Use the provided screws to mount the anti-tip bracket to the wall or floor.
5. Move the range close enough to the opening to allow for final electrical connections. Remove any shipping base, cardboard, or hardboard from under the range.
6. Move the range into its final location, making sure the rear leveling leg slides into the anti-tip bracket.
7. Move the range forward onto the shipping base, cardboard, or hardboard to continue installing the range.
8. Verify that there is adequate clearance under the range for the anti-tip bracket. The anti-tip bracket should slide under the range and onto the rear leveling leg prior to anti-tip bracket installation.
By following these steps, you can properly install the anti-tip bracket for the Whirlpool WEC310S0LS electric range and ensure the safety of your family. For more detailed instructions and illustrations, please refer to the owner's manual provided with the appliance.
Add New Comment