How do I connect the KUFATEC Audi A7 4K Complete Set Active Sound incl. Sound Booster to my vehicle? (KUFATEC Audi A7 4K Complete Set Sound Booster Instruction Manual)

Answer

manuals.plus

Jan 20, 2025 - 11:27 PM

To connect the KUFATEC Audi A7 4K Complete Set Active Sound incl. Sound Booster to your vehicle, follow these steps:

1. Connect the provided cables for CAN High and CAN Low to the cables of the marked black plug as follows:
- CAN-High (black/white) to PIN 12 (green)
- CAN-Low (black/yellow) to PIN 30 (orange/brown)

2. Connect the ground cable (brown) to the ground pin located in the side covering on the driver's side.

3. Lay the cable ignition plus Kl.15 (red/white) to the fuse box in the driver's footwell. Look for an ignition plus slot by using a multimeter. Pin the cable in the fuse box and secure it with a 10A-fuse.

4. Attach the Sound Booster module to a convenient place in the side covering (driver's side) professionally using factory materials.

5. Pull the CAN cable behind the side covering forward to the back seat. Lay the cable connection Sound Booster to the marked rubber grommet at the rear. Use a pulling tool to do so.

6. Lay the cables further to the gateway under the back seat.

7. Pull the cables for the sound generator through the marked rubber grommet down to the exhaust system (driver's side). Use a pulling tool to do so.

Please refer to the provided instruction manual for detailed diagrams and illustrations of the cable connections and routing.

Note: It is important to ensure that the installation is done correctly and according to the instructions provided. If you encounter any difficulties during the installation, you can contact KUFATEC for support via phone or email.