User Manual Q&AAnswer
Jan 20, 2025 - 10:33 PM
The installation instructions for the KUFATEC Complete Set Active Sound incl. Soundbooster can be found in the provided instruction manual. Here is a step-by-step guide based on the manual:
1. Start by disassembling the trim parts on the driver's side of the vehicle according to the instructions provided in Table 2 and Table 3 of the manual.
2. Install the sound generator in the appropriate location under the vehicle's underbody. The specific installation instructions depend on the version of the sound generator and the type of vehicle. Refer to Table 4 or Table 5 for the installation steps.
3. Connect the CAN high, CAN low, ground, and push button wires according to the instructions in Table 6. This involves removing the red plug from the fuse box, connecting the CAN wires, connecting the ignition lead, and connecting the ground cable.
4. Route the cables to the sound generator following the instructions in Table 7 and Table 8. This involves routing the cables along the vehicle's kick plates, A-pillar, rear kick plate, C-pillar, and underbody.
5. Secure the cables and connect them to the sound generator.
6. Install the software for the sound booster on a PC or Mac using the instructions in Table 9. This software allows for commissioning and further debugging of the system.
7. Configure the system using the Kufatec-Link app, which can be downloaded for free on iOS or Android devices. This step requires a Bluetooth-enabled module.
Please note that these are general instructions based on the provided manual. It is important to refer to the specific instructions and diagrams in the manual for your specific vehicle and sound generator version. If you encounter any difficulties during the installation, you can contact KUFATEC for support via phone or email as stated in the liability exclusion section of the manual.
Add New Comment