How do I set up and configure the CONCEPTRONIC GEP-0821 8-Port Gigabit PoE Switch? (CONCEPTRONIC GEP-0821 Gigabit PoE Switch Instruction Guide)

Answer

manuals.plus

Jan 20, 2025 - 10:26 PM


To set up and configure the CONCEPTRONIC GEP-0821 8-Port Gigabit PoE Switch, follow these steps:

1. Hardware Installation:
   a. Connect one end of an Ethernet cable to the switch's LAN port.
   b. Connect the other end of the Ethernet cable to your network device (e.g., router, modem).
   c. Connect your PoE devices (e.g., IP cameras, wireless access points) to the switch's PoE ports using Ethernet cables.
   d. Connect the power cord to the switch's power input and plug it into a power outlet.

2. Power On the Switch:
   Once all the connections are made, power on the switch by pressing the power button located on the front panel. The power LED should light up.

3. Default Configuration:
   The switch comes with a default configuration that should work for most basic setups. By default, all ports are in auto-negotiation mode and support PoE.

4. Optional Configuration:
   If you need to make specific configurations, such as VLANs or QoS settings, you can access the switch's web-based management interface. To do this, follow these steps:
   a. Connect a computer to one of the switch's LAN ports using an Ethernet cable.
   b. Open a web browser and enter the default IP address of the switch (usually 192.168.0.1) in the address bar.
   c. Enter the default username and password (admin/admin) to log in to the management interface.

5. Management Interface:
   Once logged in, you can access various settings and configurations. Refer to the user manual for detailed instructions on how to navigate and configure the switch's features.

Note: It is recommended to consult the user manual for advanced configurations and troubleshooting steps. The manual provides comprehensive information on all aspects of the switch's setup and usage.