User Manual Q&AAnswer
Jan 20, 2025 - 09:03 PM
To install the COLDBUSTER Under Tile and Timber Heater Kit, follow these steps:
1. Ensure that all heaters are installed according to the instructions provided in the installation guide.
2. Make sure that the floor surface is smooth, clean, and dry before installing the heaters.
3. Start each heater's cold tail on the floor below the thermostat point.
4. Plan the installation layout before starting, especially if you are installing more than one heater.
5. If the floor covering installation is delayed, protect the heater with cardboard or hardboard.
6. Test the heaters before installing the floor covering. Make sure the monitor is connected, turned on, and there is no siren sounding.
7. Ensure that the adhesives and grouts you use are suitable for use with floor heating.
8. Connect the heater to an RCD (safety switch) protected circuit.
9. Retain your invoice as proof of purchase for warranty purposes.
10. Complete the last page of the installation guide for future reference.
Please note that it is important to read the complete installation guide provided by COLDBUSTER for detailed instructions and safety precautions.
Add New Comment