User Manual Q&AAnswer
Jan 20, 2025 - 08:42 PM
To bind the receiver to the transmitter, please follow these steps:
1. Ensure that the transmitter is fitted with fully charged batteries and leave the transmitter off.
2. Plug the binding plug (included) into the channel 3 socket on the receiver.
3. Switch the receiver system on by connecting the battery or turning on a BEC operating on a controller to control. The receiver LED will begin to flash, indicating that the receiver is in bonding mode.
4. Press and hold down the binding button on the transmitter while switching it on.
5. The transmitter will begin to flash, indicating that the receiver is in bonding mode.
6. Release the binding button on the transmitter and disconnect the receiver from the battery or turn off the controller. Remove the binding plug from the receiver.
7. Switch off the transmitter and remove the binding wire. The system will be bound at the next start.
8. Install all components properly and check everything very precisely.
9. If the receiver fails to bond or does not function after bonding, repeat the above procedure until a successful bonding is achieved.
Please refer to the manual for diagrams illustrating the bonding process and the locations of the relevant components.
Add New Comment