User Manual Q&AAnswer
Jan 20, 2025 - 05:55 AM
To install the Coldbuster In Slab Heater Kit, follow these steps:
1. Ensure all heaters are installed as per the instructions provided in the installation guide.
2. Make sure the floor surface is smooth, clean, and dry before installing the heaters.
3. Start each heater cold tail on the floor below the thermostat point.
4. Plan the installation layout before starting, especially if you are installing more than one heater.
5. Install the floor cover (slab) as soon as possible after the heaters are installed.
6. Test the heaters before installing the floor covering. Make sure the monitor is connected, turned on, and no alarm is sounding.
7. Connect the heater to an RCD (safety switch) protected circuit.
8. Retain your invoice as proof of purchase for warranty purposes.
9. Complete the last page of the installation manual for future reference.
Please note the "Do Not" instructions:
- Do not cut the heating element.
- Do not allow heating elements to touch or cross one another.
- Do not place sharp or heavy objects on uncovered heaters.
- Do not install heaters under any surface not suitable for floor heating.
- Do not start installing the final floor cover before testing the heaters.
For more detailed instructions and information, refer to the COLDBUSTER In Slab Heater Kit Installation Guide provided with the product.
Add New Comment