User Manual Q&AAnswer
Jan 20, 2025 - 05:53 AM
To bind the receiver to the transmitter, please follow these steps:
1. Ensure that the transmitter is fitted with a fully charged battery and leave the transmitter off.
2. Plug the binding plug (included) into the channel 3 socket on the receiver.
3. Switch the receiver system on by connecting the battery or turn on a BEC operating on a controller to control. The receiver LED will begin to flash, indicating that the receiver is in bonding mode.
4. Press and hold down the binding button on the transmitter while switching it on.
5. The transmitter will begin to flash, indicating that the receiver is in bonding mode.
6. Release the binding button on the transmitter and disconnect the receiver from the battery or turn off the controller. Remove the binding plug from the receiver.
7. Switch off the transmitter and remove the binding wire. The system is now bound and ready to use.
Please refer to the manual for any additional information or troubleshooting steps.
Add New Comment