User Manual Q&AAnswer
Jan 20, 2025 - 05:09 AM
To bind the JAMARA CCX Pro 2'4 GHz Transmitter to the receiver, please follow these steps:
1. Ensure that the transmitter is fitted with fresh or fully charged batteries and leave the transmitter off.
2. Plug the binding plug (included) into the channel 3 socket on the receiver.
3. Switch the receiver system on by connecting the battery. The receiver LED will begin to flash, indicating that the receiver is in bonding mode.
4. Press and hold down the binding button on the transmitter while switching it on.
5. Watch the receiver LED, and once it stops blinking, the binding process is complete. This process may take up to 5 seconds.
6. Release the binding button on the transmitter and disconnect the binding plug from the receiver. Set the receiver and transmitter.
7. Install all of the components correctly and carefully check that everything is operating correctly.
8. If the receiver fails to bond or does not function after bonding, repeat the above procedure until a successful bonding is achieved.
Please refer to the "Binding" section in the JAMARA CCX Pro 2'4 GHz Transmitter instructions for more detailed information and illustrations.
Add New Comment