User Manual Q&AAnswer
Jan 20, 2025 - 04:56 AM
To properly mount the Logicbus PL Gearhead, follow these steps:
1. Slide the clamp collar fully onto the pinion gear.
2. Gently tighten the two screws on the clamp to remove any loose clearance, ensuring the distance of the gap at each end is approximately equal.
3. Slide the pinion gear with the clamp onto the motor shaft.
4. Insert the proper thickness feeler gauge between the pinion gear and motor pilot. Please note that the feeler gauge is not supplied.
5. Tighten the two clamp screws evenly and firmly, then remove the feeler gauge.
6. IMPORTANT: Tighten the two screws on the clamp to the proper torque as specified in Table A, Clamp xxxx Torques in the instruction manual.
7. Position the motor/pinion assembly vertically on a bench with the pinion gear upwards. If the gearhead requires sealing to the motor face, apply a thin film of Loctite 515 "Gasket Eliminator" or equivalent to the entire mounting surface of the motor to achieve a positive seal.
8. Lift and vertically orient the gearhead over the motor. Carefully and slowly lower the gearhead onto the pinion gear, ensuring proper alignment.
9. When the gearhead makes contact with the pinion gear, rotate the gearhead to allow the teeth to align themselves. The unit will find its alignment, and then lower the gearhead fully into position.
10. Lay the assembly horizontally on a flat surface and install the motor mounting screws, tightening them with an Allen wrench.
Please refer to the instruction manual for specific pinion gear positioning and clamp xxxx torques based on the unit size of the gearhead. The manual also provides additional clamp xxxx torques for different xxxx sizes.
For further assistance or inquiries, you can contact Logicbus through their email ventas@i091edus.com or by calling +52 (83)-3823-4349. You can also visit their website at www.tienda.logicbus.com.mx.
Add New Comment