User Manual Q&AAnswer
Jan 20, 2025 - 04:48 AM
To install the LAMPEHUSET Emil wall Nova Life Black 2 lights, please follow the instructions below:
1. Before starting the installation, make sure the power is turned off at the main switch.
2. Determine the desired location for the lamp on the wall. Ensure that the wall can support the weight of the lamp.
3. Use a stud finder to locate the studs in the wall. Mark the positions of the studs with a pencil.
4. Hold the lamp bracket against the wall at the desired height and align it with the marked positions of the studs.
5. Using a pencil, mark the xxxx holes on the wall through the holes in the lamp bracket.
6. Drill pilot holes at the marked positions using an appropriate drill bit size for the screws provided.
7. Insert wall plugs into the pilot holes, if necessary, to provide additional support.
8. Attach the lamp bracket to the wall using the screws provided. Make sure the bracket is securely fastened to the wall.
9. Connect the wiring of the lamp to the electrical junction box in the wall. Follow the wiring instructions provided in the manual or consult a qualified electrician if you are unsure.
10. Once the wiring is connected, carefully attach the lamp to the bracket by aligning the holes on the lamp with the screws on the bracket. Securely tighten the screws to hold the lamp in place.
11. Turn on the power at the main switch and test the lamp to ensure it is working properly.
Please note that these instructions are a general guide. It is always recommended to refer to the specific installation instructions provided in the LAMPEHUSET Emil wall Nova Life Black 2 lights Instruction Manual for accurate and detailed installation steps.
Add New Comment