User Manual Q&AAnswers
Jan 20, 2025 - 04:48 AM
To clean the filter of the Dr Infrared Heater DR998, follow these steps:
1. Power off the heater by pressing the POWER button on the left side of the control panel.
2. Unplug the heater's power cord.
3. Release the filter by pushing it up from below.
4. Remove the filter by pulling it down and out.
5. Clean the filter by vacuuming it to remove any dust or debris.
6. Replace the filter by sliding the top upwards into the spring-loaded slot on the back of the heater, then gently push the bottom of the filter into place.
7. Power on the heater and continue to enjoy its efficient operation.
It is recommended to clean the filter once per month or as needed to ensure the heater's efficient operation.
Jan 20, 2025 - 04:51 AM
To clean the filter of the Dr Infrared Heater DR998, follow these steps:
Turn off and unplug the heater: For safety, ensure the heater is off and disconnected from the power source before you begin cleaning.
Locate the filter: The filter is usually found on the back or side of the unit, often behind a grille or cover.
Remove the filter: Carefully remove the filter from its compartment. It may simply slide out or require you to open a cover.
Vacuum the filter: Use a vacuum cleaner with a soft brush attachment to remove dust and debris from the filter. Be gentle to avoid damaging the filter material.
Wash the filter (if applicable): If the filter is washable, rinse it under cold water. Avoid using soap or harsh chemicals, as they may damage the filter. Allow it to air dry completely before reattaching it to the heater.
Reinstall the filter: Once the filter is dry and clean, carefully slide it back into place.
Turn on the heater: Plug the heater back in and turn it on to check that it is functioning properly.
Add New Comment