User Manual Q&AAnswer
Jan 20, 2025 - 04:28 AM
To bind the JAMARA Compa X3 Evo transmitter and receiver, please follow these steps:
1. Connect the switch harness, servos, and the battery to your receiver. Make sure that both the transmitter and the receiver are turned OFF.
2. Turn the transmitter ON. The Power Indicator on the transmitter will illuminate solid red.
3. Press and hold the receiver setup button. Now switch on the receiver.
4. The receiver LED will flash quickly. Release the setup button.
5. Press and hold the binding button on the transmitter until the LED on the receiver is continuously lit.
Note: If the Bind LED on the receiver is flashing rapidly or not illuminated at all, the transmitter and receiver are not paired. In this case, turn both the transmitter and receiver OFF, then repeat the binding process.
For more detailed instructions and illustrations, please refer to the "Binding of transmitter and receiver" section in the JAMARA Compa X3 Evo Transmitter Instruction Manual.
Add New Comment