User Manual Q&AAnswer
Jan 20, 2025 - 04:12 AM
To install the ILUMINAR IL-iLOGIC8 iLogic8 Full Spectrum fixture, follow these steps:
1. Before starting the installation, ensure that you have all the necessary parts and hardware.
2. Lay the central mast on a flat surface with the attachment brackets facing up.
3. Attach each LED Bar by aligning the plastic clips and sliding them into place until you hear a soft click.
4. Once all the LED bars are attached, connect the A/C cables coming from the mast to each LED bar by aligning the connector pins and pressing the ends together. Lock the connection by twisting in opposite directions.
5. Turn the fixture over, making sure the flat surface is clear of anything that could damage the diodes.
6. If you plan to suspend mount the fixture, attach the four rope ratchets included with the fixture to the LED. Lift the LED and attach the carabiners to pre-installed hooks from the ceiling or mounting beam. The ratchets should be installed closest to the LED, not the ceiling.
7. Adjust the slack in the rope ratchets to raise or lower the fixture as needed.
8. Once the fixture is hanging with all LED bars installed, connect the power cable from the outlet to one side of the fixture.
Note: If you plan to daisy chain multiple fixtures or use the ILUMINAR HASH Controller, consult with lighting layout designers for proper spacing and connection instructions.
For more detailed instructions and safety precautions, please refer to the ILUMINAR IL-iLOGIC8 iLogic8 Full Spectrum User Manual.
Add New Comment