User Manual Q&AAnswer
Jan 20, 2025 - 03:38 AM
To connect the MartinLogan Dynamo 500 subwoofer to your home theater receiver, follow these steps:
1. Locate the subwoofer output on your home theater receiver. It is usually labeled as "Sub Out" or "LFE Out."
2. Use a high-quality RCA cable to connect the subwoofer output on your receiver to the signal input area on the rear panel of the Dynamo 500 subwoofer. The signal input area is also labeled as "LFE In."
3. Make sure the level xxxx on the subwoofer is set to the minimum position (usually labeled as "Min").
4. Plug the Dynamo 500 subwoofer into a wall outlet using the provided power cord.
5. Set the power switch on the subwoofer to "Auto On." This will allow the subwoofer to automatically enter a power-saving mode when no audio signal is detected.
6. Adjust the level xxxx on the subwoofer to a medium volume position (usually at 12 o'clock).
7. Turn on your home theater receiver and play some audio content with bass.
8. Listen to the sound and adjust the level xxxx on the subwoofer to achieve the desired bass level. Be careful not to set the level too high, as it can cause bloated bass and distortion.
By following these steps, you should be able to successfully connect the MartinLogan Dynamo 500 subwoofer to your home theater receiver and enjoy enhanced bass performance in your audio system. For more detailed information and additional control settings, refer to the user manual provided with the subwoofer.
Add New Comment