User Manual Q&AAnswer
Jan 20, 2025 - 02:20 AM
To connect the Aperion Audio Verus III Concert V8T Tower Speaker to your amplifier, follow these steps:
1. Connect a two-pole (+/-) loudspeaker cable to the binding posts located at the rear of the cabinet.
2. Use banana plugs, cable spades, or bare wires to connect the other end of the cable to the loudspeaker outputs of your switched off power amp.
3. For banana plugs, simply insert the pins into the binding post without any tightening necessary.
4. For cable spades, loosen the binding posts, insert the spade into the opening, and secure the spade by tightening the posts.
5. For bare wires, loosen the binding posts and place the cable into the binding posts. Tighten the posts.
Note: Make sure to use high-quality cables and keep the cable length as short as possible for optimal sound quality. Also, ensure that all connectors are clean and not oxidized.
For more detailed instructions and illustrations, please refer to the Aperion Audio Verus III Concert V8T Tower Speaker User Guide.
Add New Comment