User Manual Q&AAnswer
Jan 20, 2025 - 02:15 AM
To install the oceanic NDK20-21A Electric Heater, please follow the steps below:
1. Turn the body of the heater down with the bottom facing upward and unscrew the onboard screws.
2. Remove the supports by aiming the buckle on the support at the hole and pushing the supporting foot until the holes on the support coincide with the xxxx hole on the machine.
3. Insert the removed screws through the support holes and tighten them in the machine table.
4. After the installation is completed, turn the body upward for use.
Please refer to the figures in the manual for a visual representation of the installation process.
Note: It is important to ensure that the heater is placed on a horizontal and stable surface or fixed to the wall, as applicable.
Add New Comment