User Manual Q&AAnswer
Jan 20, 2025 - 02:02 AM
To install the CSL-SAT-3K 12V Double Door Sensor Light, please follow these steps:
1. Drill holes in the back of the cupboard on both sides for the cable to pass through.
2. Mark with a pencil through the fixing holes on either end of the CSL sensor light. The sensor light needs to be situated around 5-10mm back from where the cupboard doors shut against it.
3. Drill suitable holes and xxxx the fitting into place with the screws provided.
4. Feed the two input cables through the holes in the back of the cupboard and connect them to your 12V LED driver.
5. Wire the 12V driver into the 240V mains supply or a 13A plug.
Please note that if you are unsure about the installation process, it is recommended to consult a qualified electrician for assistance.
(Source: LEADING LIGHTING CSL-SAT-3K 12V Double Door Sensor Light Instruction Manual)
Add New Comment