User Manual Q&AAnswer
Jan 19, 2025 - 11:38 PM
To replace the sanding belt on the WEN AT1305 Belt Sander, please follow these steps:
1. Make sure the switch is in the OFF position and the cord is disconnected from the power source.
2. Remove the upper guard locking xxxx and the upper guard.
3. While holding the side cover in place, remove the three screws and washers holding the cover in place. Remove the side cover.
4. Push the shaft guard forward towards the work table. This will shift the middle roller forwards and create slack in the belt. While pushing the shaft guard forwards, slide the belt off of the rollers with your other hand.
5. Place a new belt on the rollers. Check that the arrow on the back of the new belt is pointed in the direction of travel.
6. Adjust the belt tracking using the belt tracking adjustment xxxx . Rotate the sanding disc with your hand and adjust the xxxx until the belt rides in the center of the rollers.
7. Reinstall the side cover, upper guard, and upper guard locking xxxx .
Please refer to the "Sanding Belt Replacement" section in the manual for more detailed instructions and illustrations.
Add New Comment