User Manual Q&AAnswer
Jan 19, 2025 - 11:05 PM
To install the Dakota Micro SSC6100 Control System Monitor Video Adapter Cable, please follow these steps:
1. Locate the camera inputs on the bottom of the Force America SSC6100 Control System Monitor. Refer to your Force America user's manual for the exact location of the camera connection ports.
2. Connect the 4-position female Samtec rectangular housing connector on the adapter cable to the corresponding video input port on the monitor.
3. Connect the 5-pin female Switchcraft connector on the adapter cable to the CVBS camera.
4. Ensure that the CVBS camera you are using is an NTSC AgCam/EnduraCam/RazerCam analog CVBS camera. The SSC6100 Control System Monitor does not accept input from AHD (Analog High Definition) cameras.
5. Once the connections are secure, power on the SSC6100 Control System Monitor and the connected camera.
6. The camera feed should now be displayed on the monitor. If not, check the connections and ensure that the camera is functioning properly.
Please note that the adapter cable is 36 inches (3 feet) long and allows for the input of one AgCam/EnduraCam/RazerCam CVBS camera into the SSC6100 Control System Monitor. The monitor has three video inputs, so you can use up to three cameras with the appropriate adapter cables.
For further assistance or warranty information, refer to the Dakota Micro user manual or contact Dakota Micro directly.
Source: To install the Dakota Micro SSC6100 Control System Monitor Video Adapter Cable, please follow these steps: 1. Locate the camera inputs on the bottom of the Force America SSC6100 Control System Monitor. Refer to your Force America user's manual for the exact location of the camera connection ports.
Add New Comment