User Manual Q&AAnswer
Jan 19, 2025 - 10:38 PM
To properly apply the McKESSON Walker Boot Non Air, please follow these steps:
1. Unfasten the straps and remove the liner from the boot.
2. Place your foot in the liner, ensuring that the heel fits snugly into the back portion of the liner.
3. Fasten and wrap the foot flaps, and then secure the leg portion of the liner. The liner should be snug from top to bottom but should not constrict.
4. With the colored "pull up" tabs intact, gently spread the side struts and place your foot onto the foot plate heel first, and then the forefoot. The ankle should be centered at the struts with the foot and ankle at a 90° angle.
5. Once in the correct alignment, remove the colored "pull up" tabs and gently push the struts towards the liner to ensure the hook and loop on the walking brace is making contact with the liner.
6. Fasten the hook and loop straps, starting at the toe and moving up the limb. Do not over tighten. Adjust the straps as necessary if swelling patterns change.
7. To remove the boot, simply unfasten the straps without removing them completely from the assembled walker. Unfasten the soft good liner and gently bring the foot and ankle forward and out of the walker. To reapply, place the foot and ankle into the liner and reattach the Velcro closures.
Note: For added comfort, you may use the extra rectangular-shaped pads for extra padding inside the liner, under the straps, between the walking brace shell and the liner, etc.
Please refer to the provided user guide for more detailed instructions and illustrations.
Add New Comment