User Manual Q&AAnswer
Jan 19, 2025 - 09:53 PM
To install the breeze33 BZ33-MSAHU24-G2-P 24,000 BTU Indoor Air Handling Unit, please follow the steps below:
1. Ensure that you have all the necessary spare parts mentioned in the user guide.
2. Start by assembling the chassis. Refer to the user guide for detailed instructions on how to assemble the chassis.
3. Install the bracket for the water collector. This bracket helps secure the water collector in place.
4. Connect the duct electronic control box subassembly. This control box allows for electronic control of the duct system.
5. Install the evaporator assembly. The evaporator is responsible for cooling the air.
6. Attach the installation plate for the main board. This plate provides support for the main board.
7. Connect the evaporator inlet and outlet pipe subassemblies. These pipes allow for the flow of refrigerant.
8. Install the e-part box subassembly. This box contains various electronic components.
9. Connect the pipe temperature sensor. This sensor helps monitor the temperature of the pipes.
10. Install the duct main control board subassembly. This control board manages the operation of the duct system.
11. Connect the linear transformer. This transformer converts the voltage for the unit.
12. Install the room temperature sensor. This sensor helps monitor the temperature of the room.
13. Connect the wire joint. This joint helps secure and connect the wires.
14. Install the fan assembly. The fan is responsible for circulating the air.
15. Connect the data transfer module control board printed board subassembly. This module allows for data transfer and control.
16. Install the brushless DC motor. This motor powers the fan assembly.
17. Attach the bracket of the main control board. This bracket provides support for the main control board.
18. Install the clamp for the cover plate assembly. This clamp secures the cover plate in place.
19. Install the air filter. The air filter helps remove dust and particles from the air.
20. Connect the wired controller. This controller allows for manual control of the unit.
21. Install the dust mesh. The dust mesh helps prevent dust from entering the unit.
22. Connect the remote controller. This controller allows for remote operation of the unit.
23. Install the upper and under cover plate assemblies. These cover plates protect the internal components.
24. Install the main and deputy water collector assemblies. These water collectors collect condensate from the unit.
Please note that these are general installation instructions. For more specific details and step-by-step instructions, refer to the user guide provided with the product.
Add New Comment