How do I install the LAP 884KJ Coldstrip 30mm Outdoor LED Recessed Deck Light Kit? (LAP 884KJ LED Recessed Deck Light Kit Instruction Manual)

Answer

manuals.plus

Jan 19, 2025 - 09:28 PM

To install the LAP 884KJ Coldstrip 30mm Outdoor LED Recessed Deck Light Kit, please follow these steps:

1. Ensure that you have all the necessary tools required for installation.

2. Read through the safety instructions provided in the manual before starting the installation.

3. Remove all packaging and wrapping from the product.

4. Decide on the appropriate location for your deck light. The product is designed to be fitted horizontally and vertically in decking, walls, steps, etc. It should not be installed directly into the ground.

5. Make sure to check the installation drawing for the correct orientation of the product.

6. It is recommended to cut the hole slightly smaller than the specified size and then file the hole until the recessed unit fits snugly.

7. Ensure that the product is properly installed and sealed to guarantee its IP65 & IP67 rating.

8. Avoid installing the product in corrosive environments and keep plants away from the lamp.

9. The maximum number of interconnected lights with the same model is 20 pieces.

10. If the product does not light up after installation, check for electricity failure and ensure all connections are secure. If in doubt, consult a qualified electrician.

11. Always disconnect the product from the mains and allow it to cool down for at least 10 minutes before performing any maintenance or adjustments.

For more detailed instructions and safety guidelines, please refer to the LAP 884KJ Coldstrip 30mm Outdoor LED Recessed Deck Light Kit Instruction Manual.