How do I inflate and deflate the Bestway 67000 Series Built In AC Pump Airbed? (Bestway 67000 Series AC Pump Airbed Owner's Manual)

Answer

manuals.plus

Jan 18, 2025 - 05:22 AM


To inflate the Bestway 67000 Series Built In AC Pump Airbed, follow these steps:

1. Ensure that the airbed is placed on a flat and clean surface.
2. Plug the built-in AC pump into a power outlet with the correct voltage (220-240V~ 50/60Hz).
3. Turn the pump switch to the "Inflate" position.
4. The pump will start inflating the airbed. Allow it to inflate for a maximum of 5 minutes or until the airbed reaches the desired firmness.
5. Once the airbed is inflated, turn off the pump by switching it to the "Off" position.
6. Close the air vent on the cover to maintain the air pressure.

To deflate the airbed, follow these steps:

1. Ensure that the airbed is on a flat surface and the air vent on the cover is open.
2. Plug the built-in AC pump into a power outlet with the correct voltage (220-240V~ 50/60Hz).
3. Turn the pump switch to the "Deflate" position.
4. The pump will start deflating the airbed. Allow it to deflate for a maximum of 5 minutes.
5. Once the airbed is deflated, turn off the pump by switching it to the "Off" position.
6. Open the air vent fully to release any remaining air.
7. Fold and store the airbed in a cool and dry place.

Please note that the motor should only be operated for short periods of time (up to 5 minutes) to avoid overheating. It is important to read and follow all the safety instructions provided in the owner's manual to ensure safe and proper usage of the airbed.