User Manual Q&AAnswer
Jan 18, 2025 - 04:52 AM
To connect your laptop to the Site Supervisor's Ethernet port (ETH1), follow these steps:
1. Under the Control Panel, go to Network and Sharing Center.
2. Select Change adapter settings.
3. Choose the Local Area Connection port that you are using.
4. Select Properties.
5. Highlight the section Internet Protocol Version 4 (TCP/IPv4) and click Properties.
6. Click Use the following IP address and enter the IP address 192.168.1.251 and the Subnet mask 255.255.255.0 of the PC being used on the Local Area Network or direct connection. Click OK.
7. Launch a preferred web browser (Microsoft Edge, Mozilla Firefox, Google Chrome, Apple Safari, or Webview on Android) and enter the IP address of the device.
8. Enter your Username/Password (default user/pass) and click Login. Then update your password to meet the minimum complexity requirements and click Save.
Note: When directly connecting your laptop or PC to ETH1, enter the default IP (192.168.1.250) into the browser address bar.
For more detailed instructions and troubleshooting, refer to the EMERSON Site Supervisor HVACR Facility Control Installation Guide or contact Emerson Electronics and Solutions Technical Support at 833-409-7505.
Add New Comment