User Manual Q&AAnswer
Jan 18, 2025 - 03:51 AM
To adjust the drive depth on the WORX WX843 20V Cordless Crown Stapler, follow these steps:
1. Locate the depth adjustment xxxx on the tool. It is usually located near the front of the tool, close to the nose.
2. Rotate the depth adjustment xxxx clockwise to increase the drive force or counterclockwise to decrease it.
3. After making an adjustment, drive a test nail into a scrap piece of material to check the depth. Repeat the adjustment if necessary until the desired depth is achieved.
Note: It is recommended to test the drive depth after each adjustment to ensure optimal performance.
Add New Comment