User Manual Q&AAnswer
Jan 18, 2025 - 02:12 AM
To install the Iceberg Thermal IceSLEET G3 CPU Cooler on your AMD or Intel processor, please follow the steps outlined in the user guide provided with the product. Here is a general guide on how to install the cooler:
1. Prepare your motherboard: Ensure that your computer is turned off and unplugged from the power source. Remove any existing CPU cooler from the motherboard.
2. Apply thermal paste: Before installing the IceSLEET G3 CPU Cooler, apply a small amount of thermal paste onto the center of your processor. This helps to improve heat transfer between the CPU and the cooler.
3. Mounting bracket installation: Depending on your processor type (AMD or Intel), attach the appropriate mounting bracket to the back of your motherboard. The user guide should provide detailed instructions on how to do this correctly.
4. Cooler installation: Place the IceSLEET G3 CPU Cooler on top of the processor, aligning the mounting holes on the cooler with the corresponding holes on the mounting bracket. Use the provided screws or clips to secure the cooler in place. Make sure it is firmly attached, but avoid overtightening the screws to prevent damage.
5. Connect the fan: Locate the fan connector on the cooler and connect it to the CPU fan header on your motherboard. This allows the fan to be controlled by the motherboard's temperature sensors.
6. Cable management: Ensure that the cables from the cooler and fan are neatly routed and do not interfere with other components or obstruct airflow.
7. Power on and test: Once the installation is complete, reconnect the power to your computer and turn it on. Monitor the CPU temperature to ensure that the cooler is functioning properly.
Please note that the above instructions are a general guide, and it is essential to refer to the specific instructions provided in the IceSLEET G3 CPU Cooler user guide for accurate installation steps and any additional considerations specific to your processor type.
Add New Comment