How do I install the Aldes EasyHome Hygro Classic Humidity-Adjustable Individual Single-Flow Ventilation Unit? (aldes EasyHome Hygro Classic Ventilation Uni Instruction Manual)

Answer

manuals.plus

Jan 18, 2025 - 01:21 AM


To install the Aldes EasyHome Hygro Classic Humidity-Adjustable Individual Single-Flow Ventilation Unit, please follow these steps:

1. Before installation, make sure to read the "Precautions and regulatory information" data sheet provided with the product.

2. Determine the installation plan based on your requirements. The unit can be attached to the wall or suspended from the ceiling. If attaching to the wall, you can use screws for added stability.

3. Block off any connections that are not being used.

4. Connect the unit to the outdoor discharge, bath/WC, and kitchen connections as needed.

5. Isolate the network, for example, by using Algaine EasyClip, to ensure proper airflow.

6. Install the terminals in utility rooms and humid rooms.

7. Make the electrical connection according to the provided instructions. The switch numbering corresponds to the fan pressure curve. The standard operation is constant speed, with the base setting at speed 4.

8. Regular maintenance is important to retain the efficiency and operating characteristics of the unit. Clean the exhaust terminals as instructed and remove dust from air inlets or change filters as needed. Use a brush to remove dust from the fan impeller.

Please note that these instructions are a general overview, and it is recommended to refer to the Aldes EasyHome Hygro Classic Humidity-Adjustable Individual Single-Flow Ventilation Unit Instruction Manual for detailed installation steps and safety precautions.