User Manual Q&AAnswer
Jan 18, 2025 - 12:55 AM
To adjust the torque setting on the QUINN 58950 Precision Torque Screwdriver Set, follow these steps:
1. Pull down the Adjusting Ring to unlock the Handle.
2. While holding the Adjusting Ring in place, turn the Handle to the right until the maximum torque setting is reached.
3. Then, turn the Handle to the left until the minimum torque setting is reached.
4. To set a specific torque value, turn the Handle until the "0" on the Scale Ring lines up with the desired value on the Main Torque Value Scale.
5. Continue turning the Handle until the corresponding number on the Scale Ring lines up with the center line on the Main Torque Scale. This will set the torque value.
6. Release the Adjusting Ring to lock the Handle in place.
Please note that the torque values on the Torque Screwdriver are marked in Inch Pounds. Make sure to use the correct units when setting the torque value.
For more detailed instructions and illustrations, please refer to the "Operating Instructions" section of the QUINN 58950 Precision Torque Screwdriver Set Owner's Manual.
Add New Comment