How do I install the RALPH LAUREN RL 5792 Ancram XL Chandelier? (RALPH LAUREN RL 5792 Ancram XL Chandelier Instruction Manual)

Answer

manuals.plus

Jan 17, 2025 - 09:13 PM


To install the RALPH LAUREN RL 5792 Ancram XL Chandelier, follow these steps:

1. Carefully remove all parts from the box and place them on a clean, soft surface.
2. Remove the collar loop (D) from the canopy (F) by removing the collar ring (G).
3. Install the mounting plate (B) to the junction box and secure it with the mounting screws (C).
4. Secure the collar loop (D) to the mounting plate (B) using pliers to tighten the locknut.
5. Install the canopy (F) to the collar loop (D) and secure it with the collar ring (G).
6. Feed the electrical and ground wires through the bottom rod (H3) and connect them to the fixture loop (I). Repeat this step for rods (H2 & H3), connecting them together using loops (E).
7. Continue feeding the wires through the top rod (H1) and connect them to rod (H2) and collar loop (D) using loops (E).
8. Cut any excess wires, making sure to leave enough to reach the junction box. Separate the wires and strip insulation on each end by 5/8".
9. Loosen the collar ring (G) and let the canopy (F) slip down and rest on the fixture loop (I).
10. Twist all fixture wires together and slip them through the center hole of the collar loop (D). Note: Untwist and separate the wires to prepare for connection.
11. Wrap the fixture ground wire (bare copper) around the green grounding  xxxx  (refer to diagram 1) and tighten it. Continue the fixture ground wire and connect it to the supply ground wire (usually green or bare copper) using a wire nut (A). It is important to ensure that the fixture is properly grounded.
12. Connect the fixture neutral wire (ribbed) to the supply neutral wire (usually white) using a wire nut (A).
13. Connect the fixture hot wire (smooth with markings) to the supply hot wire (usually black) using a wire nut (A). Be cautious not to reverse the hot and neutral connections.
14. Make sure all wire connections are tight, then carefully tuck them into the canopy.
15. Install the canopy (F) to the collar loop (D) and secure it with the collar ring (G).
16. Finally, install the light bulbs into the sockets.

Please note that these instructions are a summary of the installation steps provided in the manual. For complete and accurate installation, it is recommended to refer to the RALPH LAUREN RL 5792 Ancram XL Chandelier Instruction Manual.