How do I install the TROY LIGHTING HUCK F1093 Pendant Light? (TROY LIGHTING HUCK F1093 Pendant Light Instruction Guide)

Answer

manuals.plus

Jan 17, 2025 - 08:34 PM


To install the TROY LIGHTING HUCK F1093 Pendant Light, follow these steps:

1. Disconnect power: Before starting installation, make sure to disconnect power to the fixture by turning off the circuit breaker or removing the fuse.

2. Mounting plate: Attach the mounting plate onto the junction box using the provided mounting screws. Ensure that the junction box is securely mounted to the building structure.

3. Collar loop and  xxxx : Remove the  xxxx  collar from the collar loop. Thread the  xxxx  onto the collar loop, followed by the hex nuts and tooth washer. Thread the  xxxx  onto the mounting plate, adjusting it so that the collar loop extends 1/4" beyond the canopy. Secure using the hex nut.

4. Chain and canopy: Open the end link of the chain and attach it to the fixture assembly at the desired height. Slide the  xxxx  collar and canopy onto the chain. Attach the other end of the chain to the collar loop. Feed the wires through the chain,  xxxx  collar, canopy, collar loop,  xxxx , and mounting plate.

5. Wire connections: Cut off any excess wires and strip the insulation off the end of the leads. Attach the ground wire (green) to the ground inside the junction box or the ground  xxxx  on the mounting plate. Never connect the ground wire to the hot wire. Connect the fixture's SPT neutral wire lead (with no writings) to the neutral wire in the outlet box using an approved fastener (wire nut). Wrap the connection tightly with electrical tape, starting 1" below the fastener. Connect the fixture's SPT hot wire lead (with writings) to the hot wire in the junction box, following the same steps as the neutral wire connection.

6. Secure the fixture: Push the wires back into the junction box. Lift up the canopy to the ceiling and  xxxx  the  xxxx  collar onto the collar loop.

7. Install the bulb:  xxxx  the bulb into the socket of the fixture. Make sure not to exceed the recommended wattage of 75 watts.

8. Restore power: Once the installation is complete, restore power to the outlet at the breaker or fuse box.

For any further questions or assistance, you can contact TROY LIGHTING customer service at CustomerService@hvlgroup.com or visit their website at www.hvlgroup.com.