User Manual Q&AAnswer
Jan 17, 2025 - 05:22 AM
Sure! Here's a step-by-step guide on how to install the CONCEPTRONIC GNC-0107 Gigabit Fiber PCI Network Card:
1. Before starting the installation, make sure your computer is powered off and unplugged from the power source.
2. Open your computer case by removing the screws or latches on the side panel.
3. Locate an available PCI slot on your motherboard. The PCI slots are usually white and longer than other slots. Ensure that the slot is compatible with 32 bit PCI 1.0 or PCI 2.2 bus.
4. Remove the metal bracket covering the PCI slot by unscrewing the xxxx holding it in place.
5. Carefully align the network card with the PCI slot, ensuring that the connectors on the card line up with the slot.
6. Gently push the network card into the slot until it is fully seated. Apply even pressure on both ends of the card to avoid bending or damaging it.
7. Once the card is securely inserted, secure it in place by screwing the metal bracket back onto the case.
8. Close the computer case and secure it with the screws or latches.
9. Connect the fiber optic cable to the Gigabit Ethernet 1000Base-SX port on the network card. Ensure the connection is secure.
10. Power on your computer and wait for the operating system to detect the new hardware.
11. Install any necessary drivers for the network card. You can find the drivers on the Conceptronic website or the provided installation CD.
12. Follow the on-screen instructions to complete the driver installation.
13. Once the drivers are installed, your CONCEPTRONIC GNC-0107 Gigabit Fiber PCI Network Card is ready to use.
If you encounter any issues during the installation process, refer to the owner's manual or contact Conceptronic support for further assistance.
Add New Comment