User Manual Q&AAnswer
Jan 17, 2025 - 05:16 AM
To connect the Integral-A Series amplifiers to your speakers, you will need to use the speaker output connectors located on the rear panel of the amplifier. The amplifiers are equipped with 4-pin "Terminal Block" connectors (5.08mm-pitch).
If you are using the amplifiers in stereo mode with 4 channels, you will need to select the 4/8 ohm impedance and connect your speakers to the corresponding terminals.
If you are using the amplifiers in Bridge mode with two line channels 100/70V, you will need to select the transformer tap position (10/20/30W) and connect your speakers to the corresponding terminals.
It is recommended to use professional, high-quality, two-conductor cables for speaker connection. The speaker wires should be twisted if possible, and the maximum cable run for the line (100/70V) will depend on the cable gauge (section) and the rated power of the line.
For further details and illustrations, please refer to the "Rear panel" section of the user manual for the Integral-A Series amplifiers.
Add New Comment