User Manual Q&AAnswer
Jan 17, 2025 - 05:09 AM
To assemble the MDW-160 scale, follow these steps:
1. Pillar Installation:
- Slip the pillar over the bracket on the frame.
- Use the provided screws and lock washers to fix the pillar in a vertical position.
2. Height Rod Installation (for 'M' versions only):
- Insert the rear holes of the height rod into the two bolts on the front of the pillar.
- Loosen the height rod downwards to the right position.
- Use the provided wrench to tighten the two hex-head screws. Do not over tighten.
- Remove the wrench from the two hex-head screws.
3. Transport Wheel Installation (for 'M' versions only):
- Turn the wheel bracket so that one side is facing upwards, with the two holes opposite the rear of the frame.
- Use the provided screws and washers to fix the wheel to the platform.
- Adjust the bracket to a level position, then tighten the screws.
- When moving the scale, hold the two side faces of the pillar to keep the front edge of the platform away from the floor.
Please refer to the user manual for detailed illustrations and additional information on assembly and installation.
Add New Comment