User Manual Q&AAnswer
Jan 17, 2025 - 04:52 AM
To install the DYNOJET PC6-22100 Power Commander 6, please follow the steps outlined in the installation guide provided with the product. Here is a step-by-step guide:
1. Start by turning off the ignition before starting the installation.
2. Remove both seats, both side panels, the bodywork surrounding the fuel tank, the panel between the seats, and the plastic panel above the right footpeg.
3. Remove the fuel tank.
4. Lay the PC6 in the tail section and route the PC6 harness down the right side of the frame towards the throttle bodies.
5. Attach the ground wire of the PC6 to the negative (-) side of the battery.
6. Unplug the stock wiring harness from each injector.
7. Plug the PC6 in-line with the stock wiring harness and each injector. The PC6 ORANGE wires go to the #1 cylinder (left).
8. Unplug the stock Throttle Position Sensor (TPS) connector, which is a BLACK 3-pin connector on the right side of the throttle bodies.
9. Plug the PC6 in-line with the TPS and stock wiring harness.
10. Unplug the stock wiring harness from the ignition coils.
11. Plug the PC6 in-line with the stock ignition coils and wiring harness. The PC6 GREEN wires go to the #1 cylinder (left).
12. Unplug the stock wiring harness from the Crank Position Sensor (CPS) connector, located on the left side near the regulator/rectifier.
13. Plug the PC6 in-line with the stock wiring harness and CPS.
14. Use one of the supplied Velcro strips to secure the PC6 module in the tail section. Clean the surface area with the supplied alcohol swab before applying the Velcro.
15. Reinstall the bodywork.
For further assistance, you can download the latest map files from the DYNOJET website at dynojet.com/tunes.
If you have any additional questions or need further clarification, please consult the provided installation guide or contact DYNOJET customer support at 800-992-4993.
Add New Comment