User Manual Q&AAnswer
Jan 17, 2025 - 04:21 AM
To install the BLANCOANTAS HD or BLANCOANTAS ND Mixer Tap, please follow the steps outlined in the installation instructions provided in the manual. Here is a step-by-step guide:
1. Before starting the installation, make sure to turn off the water supply to the sink or basin.
2. Remove the existing tap or mixer from the sink or basin.
3. Clean the area where the new mixer tap will be installed to ensure a proper seal.
4. Take the mixer tap and place the rubber gasket provided onto the base of the tap.
5. Insert the tap through the mounting hole in the sink or basin.
6. Underneath the sink or basin, secure the tap in place using the mounting nut provided. Use a wrench to tighten the nut securely.
7. Connect the hot and cold water supply lines to the corresponding inlets on the tap. Ensure that the connections are tight to prevent any leaks.
8. Turn on the water supply and check for any leaks. If there are any leaks, tighten the connections further.
9. Once the tap is securely installed and there are no leaks, turn on the tap to check the water flow and temperature.
10. Adjust the mixer tap handles or levers as necessary to achieve the desired water temperature and flow.
Please note that these instructions are a general guideline and may vary slightly depending on the specific model of the BLANCOANTAS HD or BLANCOANTAS ND Mixer Tap. For more detailed instructions and illustrations, refer to the installation manual provided with the product.
Add New Comment