How do I install the circa LIGHTING PCD 5115 Comtesse Medium Uplight Chandelier? (circa Lighting PCD 5115 Comtesse Uplight Instruction Manual)

Answer

manuals.plus

Jan 17, 2025 - 03:13 AM


To install the circa LIGHTING PCD 5115 Comtesse Medium Uplight Chandelier, follow these steps:

1. Carefully remove all parts from the box and place them on a clean, soft surface.
2. Unscrew the mounting plate (C) from the canopy (F) and remove the set  xxxx  (N) and collar ring (E).
3. Install the mounting plate (C) to the junction box and secure it with the provided mounting screws (B).
4. Feed the electrical and ground wires through the bottom rod (I) and connect them to the fixture body (J). Repeat this step for the middle rod (H), connecting it to the bottom rod (I).
5. Continue feeding the wires through the canopy (F) and collar ring (E).
6. Holding the fixture upright, slide the canopy (F) and collar ring (E) down and rest them on the fixture body (J). Then connect the top rod (G) to the middle rod (H). Note: Slide the components down slowly to avoid damages.
7. Hang the fixture swivel ball (D) to the center of the mounting plate (C).
8. Install the collar ring (E) to the mounting plate (C) and secure the set  xxxx  (N) using the provided wrench (L).
9. Cut excess wires, leaving enough to reach the junction box. Separate the wires and strip insulation on each 5/8".
10. Wrap the fixture ground wire (bare copper) around the green grounding  xxxx  (refer to diagram 1) and tighten it. Then continue the fixture ground wire and connect it to the supply ground wire (usually green or bare copper) using the provided wire nut (A). Note: It is important to ground the fixture properly.
11. Connect the fixture neutral wire (white) to the supply neutral wire (usually white) using the wire nut (A).
12. Connect the fixture hot wire (black) to the supply hot wire (usually black) using the wire nut (A). Caution: Do not reverse the hot and neutral connections.
13. Ensure all wire connections are tight, then carefully tuck them into the junction box.
14. Thread the canopy (F) onto the mounting plate (C).
15. Finally, install the light bulbs into the sockets.

For cleaning the chandelier, use only a soft dry cloth or feather duster. Do not use abrasive or chemical agents.

Please note that these instructions are a summary of the manual provided. For more detailed information and diagrams, refer to the circa LIGHTING PCD 5115 Comtesse Medium Uplight Chandelier Instruction Manual.