User Manual Q&AAnswer
Jan 17, 2025 - 02:57 AM
To pair the Hunter ROAM-KIT transmitter and receiver, please follow these steps:
1. Install the receiver: Connect the receiver unit (ROAM-R) to your irrigation controller using the included SmartPort wiring harness. The SmartPort wiring harness can be extended using the optional ROAM-WH or ROAM-SCWH harnesses if needed.
2. Power up the receiver: Ensure that the receiver is connected to a 24 VAC power source. The receiver requires a power supply of 0.010 A.
3. Install batteries in the transmitter: Open the battery compartment on the transmitter unit (ROAM-TR) and insert the included 4 AAA batteries. Make sure to observe the correct polarity.
4. Pair the transmitter and receiver: Press and hold the "Pair" button on the receiver unit for 3 seconds until the LED indicator starts flashing. Then, press and hold the "Pair" button on the transmitter unit for 3 seconds until the LED indicator starts flashing. The LED indicators on both units will turn solid when the pairing is successful.
5. Test the connection: To ensure that the transmitter and receiver are properly paired, press any button on the transmitter and verify that the corresponding action is performed on the irrigation controller.
Note: The Hunter ROAM-KIT transmitter and receiver have a range of up to 300 meters (1,000 ft) in an open area. Keep in mind that obstacles such as walls and structures may reduce the effective range.
For more detailed instructions and troubleshooting information, please refer to the Hunter ROAM-KIT Transmitter and Receiver manual.
Add New Comment