How do I install the GLOBO LIGHTING 21000-4HNLMDS Pendant Lamp? (GLOBO LIGHTING 21000-4HNLMDS Pendant Lamp Instruction Manual)

Answer

manuals.plus

Jan 17, 2025 - 02:34 AM


To install the GLOBO LIGHTING 21000-4HNLMDS Pendant Lamp, please follow the steps below:

1. Ensure that the power supply is turned off before starting the installation process.

2. Identify a suitable location for the pendant lamp. Make sure the ceiling is strong enough to support the weight of the lamp.

3. Remove the lamp from its packaging and carefully inspect it for any damage.

4. Locate the mounting plate on the lamp. This is the part that will be attached to the ceiling.

5. Hold the mounting plate against the ceiling and mark the positions of the  xxxx  holes with a pencil.

6. Drill holes at the marked positions and insert the provided screws into the holes. Make sure the screws are securely fastened.

7. Connect the electrical wires from the ceiling to the corresponding wires on the pendant lamp. Follow the color coding (usually black to black and white to white) and use wire connectors to secure the connections.

8. Carefully lift the pendant lamp and align it with the mounting plate. Insert the screws through the holes on the lamp and tighten them to secure the lamp in place.

9. Once the lamp is securely installed, restore the power supply and test the lamp to ensure it is functioning properly.

Please note that these instructions are a general guideline. It is always recommended to refer to the specific instruction manual provided with the GLOBO LIGHTING 21000-4HNLMDS Pendant Lamp for detailed installation instructions and any additional safety precautions.