User Manual Q&AAnswer
Jan 17, 2025 - 01:12 AM
Sure! Here is a step-by-step installation guide for the DYNOJET PC6-18009 Power Commander 6 on your Harley-Davidson Touring motorcycle:
1. Before starting the installation, make sure the ignition is turned off.
2. Remove the seat and both side fairings of your motorcycle.
3. Remove the fuel tank.
4. Place the Power Commander 6 (PC6) next to the battery and route the PC6 harness along the left side of the frame towards the front of the engine.
5. Attach the PC6 ground wire with the small ring lug to the negative (-) terminal of the bike's battery.
6. Locate the stock Crank Position Sensor connectors on the left side of the motorcycle. Unplug the BLUE 2-pin connector pair with a RED wire and a GREEN wire.
7. Plug the PC6 wiring harness in-line with the stock Crank Position Sensor connectors.
8. Route the PC6 harness over to the right side of the motorcycle, going in front of the air box.
9. Locate the sub-harness connectors from the throttle bodies on the right side of the motorcycle. Unplug the GREY 16-pin connector pair located between the frame and the air box near the tip-over sensor.
10. Route the PC6 harness to the inside of the frame, which may require you to move the MAP sensor.
11. Plug the PC6 wiring harness in-line with the stock throttle body sub-harness connectors.
12. Reinstall the fuel tank, the removed bodywork, and the seat.
For further assistance, you can refer to the installation guide provided with the DYNOJET PC6-18009 Power Commander 6. Additionally, you can download the latest map files from the DYNOJET website at dynojet.com/tunes.
Please note that it is always recommended to consult the installation guide and follow the instructions provided by the manufacturer for a successful installation.
Add New Comment